CW 600s Lost Satellites

[taxart1040]

I did a factory default on cw600s & lost all of the satellites in ant setup, can anyone help on reloding sat's.

[tech07]

Originally Posted by taxart1040

I did a factory default on cw600s & lost all of the satellites in ant setup, can anyone help on reloding sat's.

Hi Tax, you did a Factory Default? my the rmote or with a Factory bin?
If by remote than please tell what sats you are point at and what kind of LNBs you have. DP or DSS? Are you using an External switch, if yes how are the LNBs Connected?

[taxart1040]

Thank you for responding so fast, in antenna setting satellite listings only one sat shows up, it shows up as 1. Ku_NEW Sat (OE) and this is the only sat that is listed.
PS I used the remote on the factory default.

[tech07]

Originally Posted by taxart1040

Thank you for responding so fast, in antenna setting satellite listings only one sat shows up, it shows up as 1. Ku_NEW Sat (OE) and this is the only sat that is listed.
PS I used the remote on the factory default.

YW,

Tax what sat are you trying to receive? 119W, 110W, or both?

When you go to Meanu, Dish Settings, these Sats must be listed. If they are not, then please reboot your receiver with the rear switch. COunt to 5 and check again.

If there is nothing there, you will have to load the latest File and check again.

[taxart1040]

I am trying for both 110 & 119 but I have none listed, what do you mean load latest file, do you mean BIN?

[tech07]

Originally Posted by taxart1040

I am trying for both 110 & 119 but I have none listed, what do you mean load latest file, do you mean BIN?

Yes the latest bin, like you normaly do. If the Sats appear then set up the Dish settings.

If they do not, try loading a Factory bin for that receiver

Good luck