CaptiveWorks No Channels. Please help!!

**trouble_t_roy** · #1 04-29-2009

I have a CW 700. I was getting weak signal then scrambled channel so I reloaded the lates bin file. That didn't help and now I have "No channels". I tried to reboot and even went as far as to upload the factory bin file. From there I got the "Welcome to Captiveworks" screen but still "No Channel". Please Help!!

**powerlineman** · #2 04-29-2009

My guess is that you need to do a hard boot, by turning the stb off using the rocker switch on the back of the unit. Waite a few mins, than turn it back on using the same switch. Than give the unit some time to let the keys roll over. Could take 15 to 20 mins or even longer but they will roll. Also do you have the patch enabled?

**Cougar830** · #3 04-29-2009

no channels means you have lost your sat channels maybe by accidental defautt. reset your antenna settings and scan your sats again it will get them back for you.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Up (IKS Only)	Some Models Up	Up on some channels	Down

Up (Standalone)	Some Models Up	Freezing	Up with manual keys	Up on some channels	Down