CaptiveWorks New CW 700 receiver

**spitzer635** · #1 02-12-2009

I am trying to get started on the setup of my new CW700 receiver and the first screen that I get to and can not get past is a validity check. It is asking for a serial number which I put in but then it will not validate it I guess because the screen never goes away. What should I do. I emailed the website I purchased it from and no answer yet thought I would check with you since you now so much about these receivers.

Thanks

**..razz..** · #2 02-12-2009

Hello spitzer635,
Not to worry my friend. We are here to help you. I would like you follow and read these links. They should answer all your questions. If you still have any problems just re-post again and we will try to help further.

CaptiveWorks CW700 Code Verification
How to Setup your CW700 PDF File
CaptiveWorks All In One Guide for CW 700s/800s

**spitzer635** · #3 02-12-2009

Hey I have all of those and I have been to them. The problem that I am stuck on is the varification codes I tried them and nothing works. What happens if I tried it on two may times.

**..razz..** · #4 02-12-2009

Try this one.
Entering the SERIAL NUMBER into the CaptiveWorks CW700

**spitzer635** · #5 02-12-2009

Ok I got that to work now I am trying to read the istructions in the files you gave me. I loaded the bin CW700sv2.09_2009_02_03.bin hopefully that is right. One set of instructions say do a factory defult when I go to factory defult what comes up is
ALL
Channel List Only
Radio Channel Only
Scramble Channel Only

Step 12 on the All In one guide for CW800 I am confused.

So then I went to how to set up your CW700 I believe I could make it to step 14 and when I get there I can not get the sat name E* 7,8. There is no names in my sat name. what should I do.

Thanks

**dannyzzz** · #6 02-12-2009

Quote:

Originally Posted by spitzer635

when I get there I can not get the sat name E* 7,8. There is no names in my sat name. what should I do.

Thanks

Sat E*6,8 = 110°W

**spitzer635** · #7 02-13-2009

I am confused when I go under antenna setting in the slot sat name it reads 204.7 this can not be right. There is nothing else. No E*6,8.

what do I do or what didn't I do.

**spitzer635** · #8 02-13-2009

Hey I finally am able to scan for sats. I was wondering though what should my setting be set on when I am scanning for E*9 121W
such as:
transponder
LND Freq

I am having trouble getting any channels to come up.

**renegade9999** · #9 02-13-2009

depends on the lnb you are using and the dish you have.
pretty much all the channels on 121 are now on 119

**spitzer635** · #10 02-14-2009

Yea I figure that out. Now my only question is I got channels but for some reason I am only getting channels on Ver no hoz scan. I am using a DP500 dish with 3 LNB's 1dual and 1 single. When I scan I get no quality on hoz scans. I also have a SV360 premier and I was a ble to get the hoz channels on that one, but I think it can up when I scanned. Is there a setting that needs to be turned on or off to pick up the channels on a hoz scan.

thanks