CaptiveWorks Captive work still scrambled

[spitzer635]

I loaded the latest bin posted by venon on 2/27/09 and I am still getting scrambled channels. Is there an ongoing problem. What should I do.
The last file loaded was CW700SV2.12_2009_02_27.bin

Help please

[seagorn]

Ditto here. Loaded the same bin and it was out again within a couple hours yesterday evening. Been out since.

[powerlineman]

Not sure about the CW 700, but with the 600 you need to some times do a hard boot. Turn the unit off from the back switch, leave it off a few mins. than after turning it back waite until the keys roll over. Also dont forget having the Patch enabled? F1 000. Hope this works for ya, good luck.

[toi]

hi. what is that factory cw700sv1.03. i end up with no chanels and when i scan i still cant see any of them. thanks

[powerlineman]

Toi, from what i saw in the file section, YES, the 1.03 is the latest bin for the CW700. If thats not working please post those results so the higher ups can get a newer fix, but from what i'm NOT seeing, by the way of not alot of posts, 1.03 must be OK?

[seagorn]

Originally Posted by powerlineman

Not sure about the CW 700, but with the 600 you need to some times do a hard boot. Turn the unit off from the back switch, leave it off a few mins. than after turning it back waite until the keys roll over. Also dont forget having the Patch enabled? F1 000. Hope this works for ya, good luck.

Hard reboot solved my problem. However, I have no EPGs....

Thanks for the suggestion!

[Cougar830]

For EPG's make shure your time is set correctly go to channel 239 and let it populate. Good Luck